Basic question about setting up analysis

Dear All

I'm simulating a design in HFSS, I have followed all the steps needed to setup the solution, got all green ticks on validation.

However, while setting up the basic analysis setup, the moment you open the analysis/setup menu, in the adaptive section we are asked to input a frequency. Say that is x Mhz. What does this specific x mean? 

After adding frequency sweep this x Mhz frequency is obviously included and depending on the type of sweep we choose, the meshing is done likewise. However, I am still confused as to why a single frequency x is asked. 

In the picture attached below, x has the value of 540 Ghz


Comments

  • KremellaKremella Forum Coordinator
    edited April 28

    Hello,

    Apologies for the delayed response. Have you been able to figure out an answer to your question? If you haven't, please let us know here and we will be happy to help.

    Thank you.

    Best Regards,

    Karthik

Sign In or Register to comment.