multizone mesh manual selection in ANSYS 2020R2

Hi everyone,

I am practicing on this ANSYS how to video "ANSYS Fluent: Dynamic Mesh Problem for a Piston and Reed Valve"(https://www.youtube.com/watch?v=fbaV_knzzks&t=112s&ab_channel=AnsysHowToVideos) but got stuck at the multizone mesh.

I know in older versions there is a manual selection section that allows me to select specific faces on ANSYS but in 2020 R2 it does not seem have it. So I was wondering if anyone could show me how I could manually select faces for multizone.

Best regards,

Lugia

Comments

Sign In or Register to comment.