Ansys Maxwell Transformer Transient Simulation
I'm modeling the transformer shown below, with an applied voltage of 600*cos(2*pi*100000*time). I have assigned the primary winding resistance to 0.01uOhms and the secondary winding resistance to 10kOhms, and would expect the secondary induced voltage to be 600*(10/3) = 180V. When I run a transient simulation, however, this is not the case, and my results are are shown below. The voltages are extremely high and the secondary winding induced voltages are actually higher than the primary. I am using ferrite for the core, copper for the windings, and have created a region of air around the transformer. I also have length-based assigned mesh operations for the primary and secondary windings, with the max length set at 11mm. Any help would be greatly appreciated!