Hello everyone, I have set my number of iterations 5000 for my simulation but the simulation continue to run over than 14000 . Is it normal ?
more information my mesh quality is 0.8 and time step is 0.001
This seems like an Ansys Fluent question (please confirm this).
Since you are running a transient simulation, there is number of time-steps and 'maximum' number of iterations per time-step. These two factors control the total number of iterations your simulation would run. It is important to ensure that you have sufficient iterations per time-step so you obtain a converged solution every single time-step. Please have a look at the following link for more info.
Ansys customers with active commercial software licenses can access the
customer portal and submit support questions. You will need your active account number to register.