Maxwell3D Transient Motion and Analysis Setup

ChaitanyaDSChaitanyaDS Member
edited January 12 in Electronics

I have been trying to simulate a Linear Induction Motor. I calculated the variables such as the amount of time I need to simulate, the total distance possibly covered in that time, and the maximum possible speed. I entered these values in motion and analysis setup, as well as determined band length using it.

The issue is that the amount of distance does not seem to get validated. I need it to simulate around 200 mm of motion nut it never accepts more than 4.5 mm. doesn't matter how huge or small (extreme limits) I make the band and/or time duration.

Can anyone tell the possible reasons for this issue?

Comments

Sign In or Register to comment.