Ansys Learning Forum Maintenance

NOTICE: We will be performing backend maintenance of our Learning Forum from April 5 to April 12, 2021. The result will be a new infrastructure but with little impact to user experience and design. Currently the forum is accessible in read-only mode as we complete our final migration. Thank you for your patience. For urgent issues please visit HERE.


Boundary condition with pressure and massflow at inlet — Ansys Learning Forum

Boundary condition with pressure and massflow at inlet

Hello !!!

We were given a simple nozzle model where the inlet has both a specified massflow and a pressure. Is there a way to give both the pressure and a massflow at the inlet in FLUENT ?

Please share your thoughts on this !!

Comments

  • RobRob UKForum Coordinator Posts: 8,851

    Yes and no. We can set the massflow and then set the pressure if the nozzle is supersonic. You can set a pressure inlet with a target mass flow. Ultimately, the whole point of CFD is to model the system, if we set pressure we calculate mass flow and vice versa.

Sign In or Register to comment.