saurabhiitk
Subscriber

Sir


1) i will be happy to know the steps to simulate it till 10mm only. please give me step by step instructions.


2) i have conducted tests on 24 samples under different strain rates. the samples are of different designs but all of  them have cellular spaces( some have circular spaces and some hexagonal spaces). that means i have 24 different load displacement diagram. please give me a general procedure to do the simulation for all these samples.


3) What is the difficulty in simulating it after 10mm?. Is it too difficult to do? what are the steps required to do it? is it possible for you to guide me through it.? It could have been better to do the simulation till 20mm for my thesis.


4) if it is too difficult to do this simulation for after 20mm. I will leave it as it is. 


please reply.