dinesh1995
Subscriber

My model looks like this where small cube is water reservoir and remaining is air and cylinder is the obstacle


When I was going with automatic method mesh ,it was showing divergence in the solution.
Then I tried to increase the quality of mesh by doing hexagonal mesh(which was performed by slicing the bodies like below) as by multizone option I am creating hexagonal mesh



As a result I was able to do hexagonal mesh like shown in next image 



Then when I am trying to give named selection after this it is showing following warning 



Àfter doing all this and when I am importing this mesh to setup it is showing following error 


Error: lvectorlength: wta(1) " "Error Object: ()"


 


also this thing 


Error: CAR: invalid argument [1]: wrong type [not a pair]


 


Error Object: #f


Preparing mesh for display...


Note: zone-surface: cannot create surface from sliding interface zone.


Creating empty surface.


Note: zone-surface: cannot create surface from sliding interface zone.


Creating empty surface.


Note: zone-surface: cannot create surface from sliding interface zone.


Creating empty surface.


Note: zone-surface: cannot create surface from sliding interface zone.


Creating empty surface.


Note: zone-surface: cannot create surface from sliding interface zone.


Creating empty surface.


Note: zone-surface: cannot create surface from sliding interface zone.


Creating empty surface.


Note: zone-surface: cannot create surface from sliding interface zone.


Creating empty surface.


Note: zone-surface: cannot create surface from sliding interface zone.


Creating empty surface.


Note: zone-surface: cannot create surface from sliding interface zone.


Creating empty surface.


Note: zone-surface: cannot create surface from sliding interface zone.


Creating empty surface.


Note: zone-surface: cannot create surface from sliding interface zone.


Creating empty surface.


 


 



Please look in to it and guide me