Manu19
Subscriber

Good Morning Keyur,


i think something went wrong. I wanted to reply to rwoolhou. Sorry. He asked me if i use the university licence for simulation. And 'You´re right. How did you notice? Because of the number of elements?' was the answer.


 


The simulation is in 3D. But i think that your suggestion should help, too? The difference between 2D and 3D should only be that i have to choose the airfoil area (3D) instead of the edge (2D) in inflation? Please correct me if i´m wrong. I tried your suggestion but it did not help. I don´t know if i did something wrong?


This is how the airfoil looks in Design Modeler. The Geometry should be OK?