nuqman918
Subscriber

Thank you for your intention, Mr. Rwoolhou!


At first, I set element size at 0.15m and Sizing max size at 0.15m while others at default. It showed this message :


A software execution error occurred inside the mesher.  The process suffered an unhandled exception or ran out of usable memory.



Then, I generated mesh using default setting except defeature size I reduced to 2.5e-004m and it succeed. Afterwards, the meshing procedure that were shown on the previous post was taken (edge sizing, inflation, face sizing). None of them showed any warning messages until I wanted to open in Fluent.


Today, I restarted this study. I set the element size at 0.15m and Sizing max size at 0.15m again with defeature size at 2.5e-004m. Then, the same warning showed:  


A software execution error occurred inside the mesher.  The process suffered an unhandled exception or ran out of usable memory.



Please let me know anything regarding this problem.


Thank You,


Nuqman.