Hello:n I'm a beginner for DPM function in ansys fluent. I want to ask a few question about DPM settings:n 1. In the point properties what do "velocity" and "total flow rate" refer to?n 2. Are the "velocity" and "total flow rate" have any relation with the set up what we define in inlet boundary condition? (Considering I define "Mass flow inlet" at the inlet of the whole structure mesh).n 3. Ideally I would not want to define any additional "velocity" and "total flow rate" to my particles in addition to what the inlet mass flow is.n Hope you could answer my question, Thank you.n