and ,nHope you are doing well.nI am experiencing a new problem. I have no error to run the simulation but it's only solving for either liquid or vapor phase. Not getting residual for liquid and vapor phase together.nMy inlet has only vapor (I selected volume fraction 1 in 'multiphase' option) and I have added water mass flux at the injection wall near inlet through EWF. But the simulation is not showing any value for water.(please see the attached image)nIf I selected '0' volume fraction in the inlet , the I am getting residuals for water only. No data for vapor phase.nI selected injections from interior_surface after 1s but not getting any injected droplets value.nWhat might be the problem?nI have added my mesh and residuals for your better understanding.nnThank YounAnadinn