I am using DesignModeler! My steps are Geometry, Mesh followed by Fluent. If I were to scale it down in SpaceClaim, will I be able to scale it back up to 5km? As far as I know, you need to connect a few 500 m pipes together to make it to 5 km because ANSYS only allows a part to be 500m maximum.
I tried using SpaceClaim but I am unable to find the anchor point for a circular pipe! Please help!
Please Login to Report Topic
Please Login to Share Feed
New Post - Reply To: How do you extend a pipe with inner and outer surface to 5km in length?
You are navigating away from the AIS Discovery experience