In the picture attached, I have the same number of layers with the same growth rate and first layer cell height on both edges. The application is treating the two perpendicular edges as 1 layer which I do not want. Instead I want a structured grid with inflation going upwards and another inflation layer going right (so the smallest cell will be bottom left corner and largest will be top right). I do not want to use edge sizing/bias to achieve this because I want to make sure I can specify the exact first layer cell height.
The last picture ive attached is what im trying to achieve
Please Login to Report Topic
Please Login to Share Feed
New Post - Reply To: How to achieve square mesh using inflation on 2 perpendicular edges?
You are navigating away from the AIS Discovery experience