February 6, 2023 at 1:04 pm
Royale Ohoka
Subscriber

Hi Rob, none of the courses seem to have a solution to this or tutorials on Youtube because most seem to use ICEM CFD for Meshing which is no longer offered on ANSYS 2022 R1. 

I have tried researching different methods for mesh generation but it seems that the way I have done it up until now (C-Mesh) is the most popular method. 

I have tried refining the mesh in mesh tool but still get warning in Setup tool that my minimum orthogonal quality is less than 0.01 which is far less than acceptable, however, I am still getting very reasonable results from my simulations.

Is it possible that this warning message is a glitch or something?

Thanks