Hello Peter,
I’m reviving this topic, as in one of your posts you mention that could be a good idea to include the glue in the model.
As I never did it before, I would like to ask: is there a direct way of doing that, other than creating a new part for the glue and setting its material properties? Like some sort of interface treatment. I’ve read a little bit about Cohesive Zone Modeling, but couldn’t figure out if this would be the best approach.
The glue I'll use is Araldite 2014-2.
I appreciate any comments on that. Thanks!
Henrique
You are navigating away from the AIS Discovery experience