April 20, 2023 at 1:14 am
JRK
Subscriber

Sorry about posting that link, I wasn't aware about that. 

Also, the curing simulation that I am trying to do is for a volumetric 3D printer, and so the resin before and after curing is pretty much stationary in my case. Although the solidification model may not be ideal, I am just trying to get some sort of intermediate results, in the hopes of getting a more accurate final simulation eventually.

I was able to find the equation for beta from the theory guide which I downloaded from the Ansys website.

 

I'm confused on what you mean by "If beta has an arrow next to in the panel it then you may be able to adjust this with a UDF". How can I check for this? And if I am able to adjust this with an UDF, could you please advise on how I can go about doing that? 

Thank you.