Hi,
I have been running my simulation on electronics desktop 2021 R2, the simulation runs fine. At one point, the table in the result tab of the post analysis disapear but the simulation is still running at this step and it continue whitout errors up to the full completion of the simulation. After the optimetrics simulation is finished this table stays empty.
My main complain about the reports is, as I have two design variables and a lot of outputs, the table is not as clean as the table obtained from the post analysis display/Result window (with the variation number, the design variables and the calculation outputs).
Best regards,
Rémy
You are navigating away from the AIS Discovery experience