This error goes away when I leave some gap between the shaft and rotor, however it pops up as soon as I make the shaft diameter equal to the rotor inner diameter. There is no gap between the shaft and the rotor in the machine which I am trying to model. There is no error in the motion band, but the circles being referred in the error would be the shaft and the inner rotor circumference (which touches the shaft). These circles are not segmented.
(I have included the error message and the image for this in the first question on this thread)
Looking for suggestions to to sort this error out. Thanks
Please Login to Report Topic
Please Login to Share Feed
You are navigating away from the AIS Discovery experience