Hello, I apologize for bothering you again, and thank you very much for providing the method to extract transient profile files. I have extracted profile files for all time steps and input them into the second calculation model. However, I am confused about defining the boundary conditions at the inlet. In the gauge total pressure for the pressure inlet, I selected to use the profile file I inputted. But I am not sure if this definition uses all the profile files I inputted or just the profile file from the last time step. If it only uses the profile file from the last time step, could you please tell me how to use all the profile files in the pressure inlet?
You are navigating away from the AIS Discovery experience