I tried using a compressible model first as you suggested but the simulation stopped at the same pressure again. This also happened when I tried remeshing as well so I am not sure if it has been done probably or if it worked at all. The mesh looks like this up to where the simulation stopped.
Besides the deformation, I do not notice any size difference from the original mesh. I set the max and min length scale in the remeshing parameters from the mesh info and set the max cell skewness as 0.7 as shown below.
Could you please let me know if you think I am doing something wrong or if you have any further suggestions.
Thank you.
You are navigating away from the AIS Discovery experience