July 2, 2019 at 11:32 am
Subashni Ravichandran
Ansys Employee

Hello SagarLive

In Discovery Live, you will need to follow the below steps to measure the mass of a part:

  1. Turn on the Properties panel from Live Options> Customise> Panels. (refer image) 
     
  2. Then, assign the material in this Properties panel to view the mass. (refer image)
      

Please note that the material assigned in the Physics Setup is independent of the material assigned in the Properties Panel. This is so because the material properties of Discovery SpaceClaim do not interact with material properties of Discover Live. 

Unfortunately, this can be an inconvenience while using Discovery Live. I will share your input with the product development team. Thank you for sharing your feedback