Materials

Materials

ACP – I beam modelling

    • marco.soma
      Subscriber

      Hello,

      I want to model a carbon fibre I beam. I want to model it with two plies on the right, two on the left and two on the top and bottom to connect them. From the cross section analysis the position of the layers looks correct. But ther I run the simulation (Normal Mode) and the surfaces are separated. 

      I attach the model to the following drive:

      https://drive.google.com/drive/folders/14UqxPFu_ENMmfE9Ssyxq4FnWMgxAp9Le?usp=sharing

       

      Thank you very much to everyone who tries to help me. 

      All the best

      Marco

    • Keyur Kanade
      Ansys Employee
      Duplicate of https://forum.ansys.com/forums/topic/acp-i-beam-modelling-2/
Viewing 1 reply thread
  • You must be logged in to reply to this topic.