General Mechanical

General Mechanical

Analysis results different from supposed simulation results

    • Erwins
      Subscriber

      I am a mechanical engineering student using ANSYS 2020 R1 to evaluate a prosthetic knee. My aim is to improve the design and evaluate the existing snap-fit connection and (if necessary) add a snap-fit connection to some of the components to allow for proper assembly. Before that, however, I am asked to replicate the simulation done from the researcher before me.

      Here are the boundary conditions for the simulation:

    • Erwins
      Subscriber
      I understand the problem maybe vague, but any sort of help (especially hands-on help, as there might be more to discuss about the problem) I will appreciate very much. I am on a crunch time to finish my final year project.
Viewing 1 reply thread
  • You must be logged in to reply to this topic.