Fluids

Fluids

Topics relate to Fluent, CFX, Turbogrid and more

Ansys Meshing

    • Alina Larin
      Subscriber

      Hi guys,

      I would really appreciate your help with meshing this geomtery. I get very low orthogonal quality cells in the region of those "circles". 

      Attached here the whole geometry and the section plane across those "circles".

    • Rob
      Ansys Employee

      Have a look at pinch controls. Basically, you're compressing the mesh into a very sharp crevice and that never ends well.  As a more general comment, you need more cells between the inflation to avoid problems elsewhere, and if you're using Student you may want to investigate symmetry. 

Viewing 1 reply thread
  • You must be logged in to reply to this topic.