Ansys Products

Ansys Products

AnsysWBU.exe encountered a problem. A diagnostic file has been written:

Tagged: 

    • Ozan Özdemir
      Subscriber

       Hi, I am facing with the error message down below, when I try to open the geometry on the "Mechanical". I am using 2022 R2 Student Software and all of my drivers are uptated.

    • Ashish Khemka
      Ansys Employee

      Hi Ozan,

       

      Can you create a new project and try importing the model again? This message generally is seen when the model is corrupted.

       

      Regards,

      Ashish Khemka

Viewing 1 reply thread
  • You must be logged in to reply to this topic.