General Mechanical

General Mechanical

Can i attribute the hysterisis damping property to the beam by using this APDL command?

    • RHYLANE
      Subscriber

      Hello everyone, I am analyzing the harmonic response of a beam in ANSYS workbench and I need to assign the loss factor (hysterisis or structural damping) to the beam I am studying . My question is is it possible, in my case, to add the following APDL command (MP,DMPS,MATID,0.01) below the object in the geometry branch?

    • Ashish Khemka
      Ansys Employee

      Yes, you can use the command.
      1.2. Damping (ansys.com)

      Regards Ashish Khemka
Viewing 1 reply thread
  • You must be logged in to reply to this topic.