Completely wrong temperature results with transient thermal calculation
-
-
Hey Everyone,
I have a problem with my transient thermal calculation. I have two components that are connected to each other with a contact.
Now I apply a heat load for one second and ramped to 220°C, to the smaller part. After that I deactivate the heatload and want to observe the cooling behavior of 16 sec.
So far so good. But If I now look at the temperature results, the maximum temperature after the heatload is deactivated continues to rise up to 343 degrees. How is this even possible?
Does anyone know what I did wrong?
Best regard
Tim
-
-
- You must be logged in to reply to this topic.
Boost Ansys Fluent Simulations with AWS
Computational Fluid Dynamics (CFD) helps engineers design products in which the flow of fluid components is a significant challenge. These different use cases often require large complex models to solve on a traditional workstation. Click here to join this event to learn how to leverage Ansys Fluids on the cloud, thanks to Ansys Gateway powered by AWS.
Earth Rescue – An Ansys Online Series
The climate crisis is here. But so is the human ingenuity to fight it. Earth Rescue reveals what visionary companies are doing today to engineer radical new ideas in the fight against climate change. Click here to watch the first episode.
Ansys Blog
Subscribe to the Ansys Blog to get great new content about the power of simulation delivered right to your email on a weekly basis. With content from Ansys experts, partners and customers you will learn about product development advances, thought leadership and trends and tips to better use Ansys tools. Sign up here.
-
Rob
-
Guilin Sun
-
peteroznewman
-
Ashish Kumar
-
DrAmine
You are navigating away from the AIS Discovery experience