Systems

Systems

Conservative signal link between Twin Builder and Simulink

    • gisrit
      Subscriber

      Is there a way to connect conservative, or convert non-conservative, signals in Ansys Twin Builder with Simulink? I am trying to send 3-phase currents from Simulink into an RMxprt model in Twin Builder.

      I am able to connect non-conservative signals that drive gates on a 3 phase inverter and run a motor but I want to pass conservative signals directly.

    • Jose Luis Gonzalez Hernandez
      Ansys Employee
      Hello Only non-conservative outputs are allowed for Simulink blocks. Therefore, you would need to connect signals from Simulink to physical sources in Twin Builder, and then connect to a circuit.
      Best Jose Luis
Viewing 1 reply thread
  • You must be logged in to reply to this topic.