3D Design

3D Design

Create Fine Mesh Partly

    • Gorilla Koala


      I would like to create partly fine mesh. Considering about the conputational cost, I would like to make the mesh fine at the red circle area in the figure1 and 2. How can I do that?


      figure 1: pipe geometry (symmetry)

      figure2: symmetry surface of the pipe


    • Keyur Kanade
      Ansys Employee

      You can use edge sizing or you can use Body of Influence (BOI). 

      Please check following videos

      Ansys Meshing Sizing:

      Please go through help manual for more details 



      How to access Ansys Online Help Document

      Guidelines on the Student Community


Viewing 1 reply thread
  • You must be logged in to reply to this topic.