General Mechanical

General Mechanical

Damping in ANSYS

    • afshinhashemi
      Subscriber
      Hello All,nI am trying to validate my FEA code using ANSYS. I have set all the dampings to Zero in ansys. However, I still observe damping in directional deformation of a plate in Transient Structural module. Where does the damping come from? The input is a step pressure.n
    • Daniel Shaw
      Ansys Employee
      The Newmark and HHT methods have some numerical damping. Review the settings on the TINTP command.n
Viewing 1 reply thread
  • You must be logged in to reply to this topic.