General Mechanical

General Mechanical

Deactivation elements problem(ANSYS Workbench 19.0)

    • Sherlock
      Subscriber

      Hello everyone:


      I want to use Deactivation elements to simulate the process of addictive manufacturing. But I am a freshman about this software.The imformation about this problem on the network is too little.Could you give me some suggestion?


      THANK YOU VERY MUCH!!!

    • Sandeep Medikonda
      Ansys Employee

      Hi Sherlock,


      Please see the posts by emmanuel and ashish.



       


      Note that additive simulations uses EKILL/EALIVE commands in addition to some other commands. So, checkout the Additive analysis guide and these commands in help. If you can't access the documentation, see here.


      Take a moment to review the Guidelines on the Student Community


      Regards,
      Sandeep

    • Sherlock
      Subscriber

      Roger that.


      THANK YOU Sandeep.  

Viewing 2 reply threads
  • You must be logged in to reply to this topic.