-
-
August 9, 2018 at 3:37 pm
HZhang
SubscriberWe have run into an issue with domain interface for a stirred tank. The velocity profile is attached. It is not correct to have an interface boundary for the velocity profile. We have created three interfaces for the top, bottom and side boundaries of the inner zones, setting up the interface wall for the inner zone is moving wall but relative to the zone with a zero speed. Any comments?
-
August 9, 2018 at 8:40 pm
Raef.Kobeissi
SubscriberHi,
Can you explain what you mean by this:
It is not correct to have an interface boundary for the velocity profile.
Can you upload the case to properly understand the setup.
Thank you
-
- The topic ‘domain Interface issue’ is closed to new replies.

Boost Ansys Fluent Simulations with AWS
Computational Fluid Dynamics (CFD) helps engineers design products in which the flow of fluid components is a significant challenge. These different use cases often require large complex models to solve on a traditional workstation. Click here to join this event to learn how to leverage Ansys Fluids on the cloud, thanks to Ansys Gateway powered by AWS.

Earth Rescue – An Ansys Online Series
The climate crisis is here. But so is the human ingenuity to fight it. Earth Rescue reveals what visionary companies are doing today to engineer radical new ideas in the fight against climate change. Click here to watch the first episode.

Ansys Blog
Subscribe to the Ansys Blog to get great new content about the power of simulation delivered right to your email on a weekly basis. With content from Ansys experts, partners and customers you will learn about product development advances, thought leadership and trends and tips to better use Ansys tools. Sign up here.
- legend min and max
- Ensight hot iron palette from an image
- Streamlines in EnSight using MRI data
- Import MRI data into Ensight
- FLUENT APPLICATIION ERROR
- Total Surface Heat Flux Calculation in Fluent
- Drop Test of a Water-Filled Tube
- Difference between “total pressure” and “absolute pressure”?
- obtaining pressure distribution by making points in ansys
- Minimum Orthogonal Quality Less than 0.01 For Transonic Airfoil Flow Analysis
-
8824
-
4658
-
3155
-
1688
-
1482
© 2023 Copyright ANSYS, Inc. All rights reserved.