General Mechanical

General Mechanical

Energy Harvesting using Piezo and MEMS Extension

    • fxl930
      Subscriber

      HI~


      I am using the ANSYS20 to simulate the piezo-energy harvester. However, i can not obtain the voltage output in frequency voltage plot as attached. And, it keeps showing the message "  The maximum contact stiffness is too big. This may affect the accuracy of the results. You may need to scale the force unit in the model." 


      How could i deal with these problems to obtain the voltage.


      Thanks. 


Viewing 0 reply threads
  • You must be logged in to reply to this topic.