Ansys Products

Ansys Products

Error in ANSYS magnetostatic

    • piotr.kucia
      Subscriber

      Hello

      I am a new ANSYS user, trying to learn how to use the magnetostatic module. Currently I am attempting to solve simulation of two ferromagnetic plates, however each run ends in a message of "unknown error occuring". After checking in the solver, it contains an error message about "C on the MP command" not being available. I would appreciate if someone let me know what does that mean, and how could I rectify this issue.

       

       

       

      Regards, Piotr

    • Mike Rife
      Ansys Employee

      Hi piotr.kucia Try defining the material model directly instead of using one from the libraries.  C is a thermal property.  Mike

Viewing 1 reply thread
  • You must be logged in to reply to this topic.