July 16, 2023 at 7:28 pmShamkhal MammadovSubscriber
I am running a 2d simulation of a 2 by 60-inch pipe.
my BCs are the following:
inlet: 100.2 psi
outlet 100 psi
CO2 is real gas, viscosity changes with temperature. The H2O volume fraction at the inlet is 0.1.
The simulation runs nice until H2O hits the outlet boundary, then I am getting an error message.
July 17, 2023 at 8:39 amRobAnsys Employee
If you're only losing 0.2psi how big a change in CO2 properties are you expecting? What outlet boundary did you use?
- You must be logged in to reply to this topic.
Boost Ansys Fluent Simulations with AWS
Computational Fluid Dynamics (CFD) helps engineers design products in which the flow of fluid components is a significant challenge. These different use cases often require large complex models to solve on a traditional workstation. Click here to join this event to learn how to leverage Ansys Fluids on the cloud, thanks to Ansys Gateway powered by AWS.
Earth Rescue – An Ansys Online Series
The climate crisis is here. But so is the human ingenuity to fight it. Earth Rescue reveals what visionary companies are doing today to engineer radical new ideas in the fight against climate change. Click here to watch the first episode.
Subscribe to the Ansys Blog to get great new content about the power of simulation delivered right to your email on a weekly basis. With content from Ansys experts, partners and customers you will learn about product development advances, thought leadership and trends and tips to better use Ansys tools. Sign up here.
- License Error
- Error with workbench SceneGraphChart
- Sizing on Ansys Workbench 19.2
- Workbench not opening
- Error: Exception of type ‘Ansys.Fluent.Cortex.Cortex not availableException’ was thrown
- Workbench error
- how to open DesignModeler
- FlexNet Licensing – Not running
- Problem with FlexNet Licensing
- An error occurred when the post processor attempted to load a specific result.
© 2023 Copyright ANSYS, Inc. All rights reserved.