反射率

- March 12, 2023 at 12:35 pm
  
  221068316
  Subscriber
  
  为什么仿真薄膜反射率的时候会出现尖峰，并且其反射率会大于1
- March 13, 2023 at 7:25 pm
  
  Guilin Sun
  Ansys Employee
  
  一般情况是仿真时间不够造成的。你这个情况很可能是因为autoshutoff min 太大造成仿真时间不够。建议：
  将仿真时间增加100倍，将autoshutoff min 降低到1e-7测试看看。
  参见
  Ansys Insight: 透射率反射率大于1，或者透射率反射率之和大于1的原因与解决方案–综合贴
  - March 14, 2023 at 1:36 am
    
    221068316
    Subscriber
    
    好的谢谢，还有一个问题就是如果运行过程中运行状态超过95%还没结束是不是也存在运行时间问题
- March 14, 2023 at 4:00 pm
  
  Guilin Sun
  Ansys Employee
  
  原则上说99%之前都可以，但是为了保险器件我建议小于95%。将仿真时间设置长一点没有任何问题。

Viewing 2 reply threads

You must be logged in to reply to this topic.

Ansys Innovation Space

Boost Ansys Fluent Simulations with AWS

Computational Fluid Dynamics (CFD) helps engineers design products in which the flow of fluid components is a significant challenge. These different use cases often require large complex models to solve on a traditional workstation. Click here to join this event to learn how to leverage Ansys Fluids on the cloud, thanks to Ansys Gateway powered by AWS.

Earth Rescue – An Ansys Online Series

The climate crisis is here. But so is the human ingenuity to fight it. Earth Rescue reveals what visionary companies are doing today to engineer radical new ideas in the fight against climate change. Click here to watch the first episode.

Ansys Blog

Subscribe to the Ansys Blog to get great new content about the power of simulation delivered right to your email on a weekly basis. With content from Ansys experts, partners and customers you will learn about product development advances, thought leadership and trends and tips to better use Ansys tools. Sign up here.

Trending discussions