General Mechanical

General Mechanical

Topics relate to Mechanical Enterprise, Motion, Additive Print and more

General Error

    • Hasan Ilker ÇELİKER
      Subscriber

       

      An error occurred inside the SOLVER module: general error. 

       

      Why? How can I fix?

    • Ashish Khemka
      Forum Moderator

      Hi,

       

      Can you please share the snapshot of the error message from Solver Output (please refer to the image below, where to look for error)? Also, please share the applied boundary conditions snapshots.

      Regards,

      Ashish Khemka

    • Rahul Kumbhar
      Ansys Employee

      Please check the faces/edges selected in boundary conditions/contacts etc are not defeatured while meshing. If the scoped geometry selection does not have mesh due to defeature, then this error may appear.

Viewing 2 reply threads
  • You must be logged in to reply to this topic.