General Mechanical

General Mechanical

Having a problem with oriented Selection set

    • Rasackyousof
      Subscriber
      I am trying to model a T-section and make a leg and right bonding (L-shaped) for it but I am having a problem with the direction of defining a direction for the bond. I want the vertical and the horizontal elements of the L-shaped bond to have the same direction for oriented selection set. Can anyone help, please. I am working on a project and it is really important.
      Thanks a lot.
    • peteroznewman
      Subscriber

      It took me a minute to figure out that the image attached above and pasted below was shot with a camera taking a picture of a cracked monitor glass with some ansys graphics displayed.



      Rasakyousf, please learn how to use the Windows Snipping Tool or some other screen grab utility so I never have to look at your sad monitor again!


      That said, I don't know how to help you with the orientation set since it seems like an APDL thing, and I am a beginner in that area.


      Regards,


      Peter

Viewing 1 reply thread
  • You must be logged in to reply to this topic.