Fluids

Fluids

How do I create a section plane in CFD post?

    • lyonsp4
      Subscriber
      Hello, I am a complete beginner to ANSYS and have recently completed my first 3D simulation of a countercurrent heat exchanger. I was wondering, is there a way to produce a section plane on this result so that I can cut the result down the middle and still retain the 3D appearance instead of just a flat plane? I would like to keep the model with the 3d look like the bottom image, not like the top image.
    • DrAmine
      Ansys Employee
      I do not understand the requirement but are you trying to create a cut plane: then create a x based plane (Plane YZ in Ansys Fluent).
Viewing 1 reply thread
  • You must be logged in to reply to this topic.