General Mechanical

General Mechanical

How to check the potential of design using stress analysis

    • Ananth Narayan
      Subscriber

      Hello everybody,


                               I have a doubt regarding static analysis. If I suppose to design and analysis the member, what are the factors I should see for success of that model. Also how should I know that the member will fail for certain force or pressure and safe load

    • Sandeep Medikonda
      Ansys Employee

      Ananth,


        You can use some of the Stress Tools to get a rough idea.


      Regards,
      Sandeep

Viewing 1 reply thread
  • You must be logged in to reply to this topic.