How to set Initial Position in Twinbuilder/Simplorer

    • hassa124

      Good afternoon,

      When doing a Maxwell/Twinbuilder co-simulation, the initial position is not set. How do you setup the initial condition the position of a Maxwell 2D simulation?

    • Navya C
      Ansys Employee

      Your question is being answered in the below post.
      Please restrain from creating duplicate posts
      How to set Initial Position in Twinbuilder/Simplorer; Urgent ÔÇö Ansys Learning Forum

      Regards Navya
Viewing 1 reply thread
  • You must be logged in to reply to this topic.