January 19, 2022 at 8:33 pmAfroJodocusKwakSubscriber
So, what I mean to ask is the following: I have a geometry of an artery, which was made based on the diastolic state of it. This means that a certain pressure (~10 kPa) is already acting on it, while Mechanical "thinks" there is no force working on it yet.
This is an image of the artery geometry:January 19, 2022 at 10:48 pmpeteroznewmanSubscriberRead the ANSYS Help, Mechanical APDL, Structural Analysis Guide, Chapter 8.7 on Inverse Solving.
That starts with the deformed shape with a known load and solves for what the shape of the part is with no load.
Open ANSYS Help and copy the URL below, then paste that into the address of the browser running ANSYS Help.
January 19, 2022 at 11:02 pmAfroJodocusKwakSubscriberthank you for your help. I'll take a look at the link and hopefully figure it out :)
Viewing 2 reply threads
Ansys Innovation Space
- You must be logged in to reply to this topic.
Simulation World 2022
Earth Rescue – An Ansys Online Series
Ansys BlogTrending discussions
- How to calculate the residual stress on a coating by Vickers indentation?
- Errors – Reinforced Concrete Beam
- Solver Pivot Warning in Beam Element Model
- An Unknown error occurred during solution. Check the Solver Output…..
- The solver engine was unable to converge on a solution for the nonlinear problem as constrained.
- whether have the difference between using contact and target bodies
- Massive amount of memory (RAM) required for solve
- Cannot apply load on node
- Large deflection
- Colors and Mesh Display
Top Rated Tags