January 26, 2022 at 9:48 pmnikimehSubscriber
When I setup 2 modes in waveport setup in HFSS design and simulate. After the simulation is complete, the gamma plot is not showing the 2nd mode in the plot. It works in version 2019 but not in 2020 and 2021. Can you please check and update if required.
Note that the Zo plot shows the 2nd mode. All pictures have been attached.January 27, 2022 at 7:16 amErik KostsonAnsys EmployeeHi
Please post this in the electronics forum.
Closing this post.
Viewing 1 reply thread
Ansys Innovation Space
- You must be logged in to reply to this topic.
Simulation World 2022
Earth Rescue – An Ansys Online Series
Ansys BlogTrending discussions
- How to work with STL file?
- drawing a geometry by importing a table of points
- Parameters not imported into Workbench 18.2 from Solidworks/Inventor
- section plane
- material properties
- Cant import spaceclaim model into fluent mesher
- Ansys Mechanical Unable to get model
- Missing faces on solid bodies
- how to fill solid between two surfaces?
- Importing drawing file to Ansys Design Modeler
Top Rated Tags