Electronics

Electronics

Maxwell 2D and Maxwell Simplorer Setups not matching

    • hassa124
      Subscriber

      Good afternoon,

      I have a Maxwell 2D setup with a motor, and another setup with Simplorer co-simulation of the same motor.

      The Operation condition is 245 V, at 50 degrees (voltage angle)

      Here is the Torque Profile and Current Profile for the Maxwell 2D:

    • HDLI
      Ansys Employee

      Could you show and check the setting of E1~3, voltage source, in Simplorer model? and setting of V_ROT1? Please add unit in resistance and inductance in the Simplorer mode. Thanks.
      HDLI
Viewing 1 reply thread
  • You must be logged in to reply to this topic.