Ansys Products

Ansys Products

Discuss installation & licensing of our Ansys Teaching and Research products


    • Rezwana Popsi

      I am looking for ways to club the inverter model from simulink and the motor model from motor-CAD in Simulink. Is it possible to get an FMU of the motor-CAD model where I can vary the geometric parameters such as stator bore diameter, slot opening, rotor magnet length, air gap etc?

    • GLUO
      Ansys Employee


      Please use custom FMU and check if the parameters you need are listed in Help>>ActiveX Parameter Names. There is a tutorial in Motor-CAD installation folder.


Viewing 1 reply thread
  • You must be logged in to reply to this topic.