multizone meshing problem

- October 9, 2023 at 6:09 am
  
  Sonu kumar
  Subscriber
  
  sir,after doing multizone meshing when i am going to check the crossectional view it is not showing properly. instead of it meshing is comming along the crossection loop in close loop.
- October 9, 2023 at 8:48 am
  
  Rob
  Forum Moderator
  
  That's impressive. How does the geometry look? You may need to split the zone to have 2+ pipes and an elbow.

Viewing 1 reply thread

You must be logged in to reply to this topic.

Ansys Innovation Space

SimACE-23

Boost Ansys Fluent Simulations with AWS

Computational Fluid Dynamics (CFD) helps engineers design products in which the flow of fluid components is a significant challenge. These different use cases often require large complex models to solve on a traditional workstation. Click here to join this event to learn how to leverage Ansys Fluids on the cloud, thanks to Ansys Gateway powered by AWS.

Earth Rescue – An Ansys Online Series

The climate crisis is here. But so is the human ingenuity to fight it. Earth Rescue reveals what visionary companies are doing today to engineer radical new ideas in the fight against climate change. Click here to watch the first episode.

Ansys Blog

Subscribe to the Ansys Blog to get great new content about the power of simulation delivered right to your email on a weekly basis. With content from Ansys experts, partners and customers you will learn about product development advances, thought leadership and trends and tips to better use Ansys tools. Sign up here.

Trending discussions