Platform

Platform

Parameters are not taken into account while using table of design points

    • HugoB
      Subscriber

      Hello everyone,


      I have a problem with the table of design points, I want to calculate the drag on a cylinder in 2D for differents velocity inlets magnitudes and differents cylinders radius, but when I'm setting those two as parameters and making them vary in a table of design points, Fluent just returns me the same drag for every one without changing the parameters values for each design point...


      I even have a message telling me that the velocity inlet is not taken into account for the calculation of my design point...


      Could you tell me how do I have to proceed in order to make Fluent understand that I want him to change the radius and the velocity inlet for each design point ? I couldn't find anything on the Ansys help document or on the Internet...


      Thank you very much in advance for your help and have a nice day ! 


      Here are some screenshots of what I mean : 



       

Viewing 0 reply threads
  • You must be logged in to reply to this topic.