General Mechanical

General Mechanical

Pre-Meshed Crack

    • Abdoon075

      Hello Experts ...

      I've modeled a quarter stiffend panel (with symmetry ) with a crack in its center. Then I choose a pre-meshed crack and select the crack tip 

      I have found in the details of pre-meshed an option of symmetry, should I put it yes or No ??


    • Wenlong
      Ansys Employee

      The definition of the symmetry is shown below:

      "Symmetry: Specifies the crack symmetry about a line (in 2D analysis) or about a plane (in 3D analysis). The default is No."


      Since you have symmetric geometry (and crack), I would turn it to Yes.




Viewing 1 reply thread
  • You must be logged in to reply to this topic.