Electronics

Electronics

Quality mesh

    • knnn
      Subscriber

      when I run a transient simulation in ANSYS maxwell, I get a final error saying "quality of mesh is not acceptable for this solution" no matter how small I make the mesh. How do I fix this issue?

    • Mark Solveson
      Ansys Employee

      Try changing to either Classic or TAU mesh in the Initial Mesh Settings.  


      Delete mesh operations to see if this is over-constraining the mesh to the geometry.  

    • knnn
      Subscriber

      I have done that it does not change anything, but thank you for the suggestion

Viewing 2 reply threads
  • You must be logged in to reply to this topic.